Development of water jet ejector with a wide range of flow characteristics


Аuthors

Basharina T. A.*, Yeltsov I. S.**, Akolzin I. V.***, Kruzhaev K. V.****

LLC SPE "InterPolaris", Novovoronezh, Russia

*e-mail: ta@interpolyaris.ru
**e-mail: eltsov@interpolyaris.ru
***e-mail: akolziniv@interpolyaris.ru
****e-mail: kruzhaev@interpolyaris.ru

Abstract

The article presents the results of the development and hydrodynamic studies of the operating modes of a water jet ejector operating in a wide range of flow characteristics (3-100 l/min) and representing a jet pump with axial supply of an active (working) single-phase liquid medium and radial supply of a passive (ejectable) single-phase liquid medium. In the course of a computational experiment with subsequent verification of the results with a full-scale experiment, operable and inoperable modes of operation of the device were identified, the dependence of efficiency on the values of active and passive media consumption in a wide range was obtained. The basis for the computational experiment is a geometric model of the flow area of the working fluid, in which the simulation of the area of reduced pressure in the receiving chamber occurs by the outflow of the active medium at high speed through the working nozzle and subsequent pumping of the ejected medium. Of the 25 designs of the water jet ejector, the most promising one was selected, the confirmation of the operability of which was carried out in 9409 operating modes. Several main structural elements have been identified, each of which, as it was found, significantly affects the functioning of the device. The conducted research allowed us to identify practical recommendations used in the development. In the verification process, the difference between the computational experiment and the full-scale one was established, not exceeding 5%, which corresponds to sufficient engineering accuracy. The high degree of reliability of the results obtained, confirmed by field tests, allows the use of this water jet ejector of the developed design in the task of pumping media with a wide range of volumetric flow rates.

Keywords:

water jet ejector, numerical modeling, field experiment, hydrodynamic study

References

  1. Sokolov E.Ya., Zinger N.M. Struinye apparaty (Jet devices), Moscow, Energoatomizdat, 1989, 352 p.

  2. Aleksandrov V.Yu., Klimovskii K.K. Optimal'nye ezhektory (teoriya i raschet) (Optimal ejectors (theory and calculation), Moscow, Mashinostroenie, 2012, 136 p.

  3. Sazonov Yu.A. Raschet i konstruirovanie struinykh apparatov (Calculation and design of jet devices), Moscow, RGU nefti i gaza imeni I.M. Gubkina, 2016, 64 p.

  4. Spiridonov E.K. Vestnik Yuzhno-Ural'skogo gosudarstvennogo universiteta. Seriya: Mashinostroenie, 2005, no. 1 (41), pp. 94-104.

  5. Aronson K.E. et al. Parogazoturbinnye ustanovki: ezhektory kondensatsionnykh ustanovok (Steam and gas turbine units: ejectors of condensing units), Moscow, Yurait, 2017, 129 p.

  6. Abramovich G.N., Girshovich T.A., Krasheninnikov S.Yu., Sekundov A.N., Smirnova I.P. Teoriya turbulentnykh strui (Theory of turbulent jets), Moscow, Nauka, 1984, 716 p.

  7. Sazonov Yu.A. Osnovy rascheta i konstruirovaniya nasosno-ezhektornykh ustanovok (Fundamentals of calculation and design of pump-ejector installations), Moscow, RGU im. I.M. Gubkina, 2012, 302 p.

  8. Yang X.L., Long X.P. Numerical investigation on the jet pump performance based on different turbulence models, IOP Conference Series Earth and Environmental Science, 2012, vol. 15 (5), pp. 2019. DOI: 10.1088/1755-1315/15/5/052019

  9. WeiXiong C., ChenXi H., YuPing B., DaoTong C. Experimental and numerical investigation of two phase ejector performance with the water injected into the induced flow, International Journal of Advanced Nuclear Reactor Design and Technology, 2020, vol. 2, pp. 15-24. DOI: 10.1016/j.jandt.2020.01.001

  10. Sheha A.A.A., Nasr M., Hosien M.A., Wahba E.M. Computational and Experimental Study on the Water-Jet Pump Performance, Journal of Applied Fluid Mechanics, 2018, vol. 11, pp. 1013-1020. DOI: 10.29252/jafm.11.04.28407

  11. Bogdanov E.I. Oborudovanie dlya transporta i promyvki peskov rossypei (Equipment for transport and washing of placer sands), Moscow, Nedra, 1978, 240 p.

  12. Lyamaev B.F. Gidrostruinye nasosy i ustanovki (Hydrojet pumps and installations Engineering), Moscow, Mashinostroenie, 1988, 256 p.

  13. Satish P. Mehta. Study of water jet pumps, Kansas State University, 1968, 68 p.

  14. Larina E.V., Tsipenko A.V. Trudy MAI, 2017, no. 97. URL: https://trudymai.ru/eng/published.php?ID=87135

  15. Pis'mennyi V.L. Trudy MAI, 2003, no. 12. URL: https://trudymai.ru/eng/published.php?ID=34456

  16. Pis'mennyi V.L. Trudy MAI, 2003, no. 11. URL: https://trudymai.ru/eng/published.php?ID=34476

  17. Korn G., Korn T. Spravochnik po matematike dlya nauchnykh rabotnikov i inzhenerov (Handbook of mathematics for scientists and engineers), Moscow, Nauka, 1973, 831 p.

  18. Zhulev Yu.G., Potapov Yu.F. Trudy TsAGI, 1978, no. 1958, pp. 3-20.

  19. Eremin A.M. Trudy MAI, 2023, no. 130. URL: https://trudymai.ru/eng/published.php?ID=174600. DOI: 10.34759/trd-2023-130-05

  20. Tsegel'skii V.G. Struinye apparaty (Jet devices), Moscow, Izd-vo MGTU im. N.E. Baumana, 2017, 576 p.


Download

mai.ru — informational site MAI

Copyright © 2000-2024 by MAI

 Вход